01 / Survey identification
Planning estimates only. Enter installed cable length including slack, service loops and jumpers. Data stays in this browser unless exported.
02 / RF chain
Inline hardware
Enter loss per actual item or mated interface. Do not double-count assemblies. Loss is treated as constant across selected bands. Defaults are assumptions, not component specifications.
03 / Receiver & antenna
Frequency selection
DC bias check
Example DC values must be replaced with the exact receiver and antenna specifications. Single DC path, constant load only; no bias tees or powered splitters modeled. Gain assumed constant across bands. The 25–35 dB preferred interval is OEM7 guidance only.
04 / Engineering results
05 / Compare alternate cable
Comparison substitutes one cable type for all cable segments while maintaining total length and hardware assumptions. Physical routing, rating, termination, jacket, cost and installation suitability require separate review.
06 / Installed validation
RF estimates do not establish operational receiver performance. Measure S21, return loss, DC continuity and antenna voltage, then verify receiver tracking and timing as applicable.
Method, sources and limitations
Typical attenuation at 25°C, matched 50 Ω: (a√f + bf) × length(ft)/100. Frequency in MHz. Losses add in dB. Net gain = antenna LNA gain minus total loss. Maximum length assumes uniform scaling of the selected cable mix, unchanged hardware, and minimum gain plus requested reserve; it does not establish compliance with upper gain or DC limits. Delay uses length / (c × velocity factor) and excludes hardware delay. DC voltage is an ohmic estimate using center + shield resistance and user-entered series resistance; no temperature corrections or mismatch modeling.
Times Microwave LMR-240 · LMR-400 · NovAtel APN-077
Catalog covers standard variants only. Confirm exact part number. No predicted C/N₀, absolute signal power, noise figure, VSWR, surge safety or timing accuracy certification.